IP cameras now take a tile in Broadcasteer

The camera already on your ceiling can join the Studio. Find it on the network, sign in once, see a real picture, then use it. On every plan.

By Abelitie · November 11, 2026
IP cameras now take a tile in Broadcasteer

What is new

An empty camera tile in the Studio now offers IP Cam beside Phone, USB and NDI.

An IP camera is one that plugs into your network rather than into a computer. Some halls and churches already have one, a dome on the ceiling or a camera on a side wall. Until now, Broadcasteer had no way to reach it directly.

Available now on every plan, like USB and NDI, within your plan's camera count.

How it works for you

Tap IP Cam on an empty tile. Broadcasteer looks for cameras on your network and lists what it finds.

Sign in once. Use the camera's own username and password.

See it before you use it. You get a real picture from the camera on the spot, so you know you have the right one before it goes anywhere near the service.

Use it. The tile goes live and behaves like your other cameras. Ctrl+1 to 5 takes a camera to air, and REC and RAW record it. RAW is MAX and ALPHA.

If Find does not see it, paste the camera's stream address instead. Most cameras print it in their manual or settings page.

Each camera is remembered after that. If a router restart hands it a new address, Broadcasteer finds it again without you going back to its settings.

Room to breathe

Every IP camera has to be encoded by the PC, and encoding costs something. So this release also brings a rule. The PC keeps 20% of itself free.

A new camera waits if there is no room. The tile says the PC is busy, and the camera starts when there is space.

If the graphics card runs short, one off-air IP camera steps to a lighter encoder after about ten seconds. When room comes back, it climbs back up, trying at most once every five minutes.

The camera on air is never touched. Not to make room, not for anything.

You can see it. The load shows beside CPU in the status bar, and it turns red when you are under that 20%. Guardian shows it too.

Who benefits

A church with a fixed camera already installed. That camera was paid for long ago. It may as well earn its place in the service.

A hall with no one free to hold a phone. A wide shot from the back wall needs no volunteer, no charger and no tripod in the aisle.

A school or sports hall. A permanent camera can serve an event without anyone climbing a ladder.

The team mixing phones and fixed cameras. All of them land in the same tile row, and the switching works the same way.

Being straight about it

I have not proved this against your camera. The whole flow has run in a real browser against test cameras that speak the same standards as the real thing. My records show no branded camera behind it when 5.0 went out, and real cameras are where surprises live. If yours misbehaves, tell me which one.

Video only. No sound comes from the camera, by design. Sound stays on your mixer and comes in through the Studio.

No pan, tilt or zoom control. The Studio reads the picture only. A PTZ camera still moves with its own remote or app.

Same network only. The camera has to be on your PC's network, so a camera at the far end of town needs a phone or another route.

It is not free for the PC. A phone encodes its own picture. An IP camera is encoded by your Studio PC, which is why a PC with a graphics card carries more of them. An older laptop will reach its limit sooner, and the tile will tell you.

The Floor Director can cut to it but not preview it. The Floor Director's phone cuts to an IP camera just as it does for USB and NDI, with no preview of the picture on the phone.

Some cameras lock you out after wrong passwords. That is the camera's own rule, not mine. Get the login right before you try again and again.

Two rulings behind it

I put IP cameras on every plan, the same as USB capture and NDI.

The 20% rule came in the middle of building this. My note at the time was blunt... the PC must be at 20% free at all times, bump up only with 20% free, step down when it is less. So now the PC has to answer that before it takes on another camera.

Practical notes

Find the password before Saturday. Whoever installed the camera may have set it years ago. That is usually the hardest step.

Put the camera and the PC on the same network. A camera on a separate security network will not show up.

Use a wired connection where you can. A camera on a cable and a PC on a cable make the least drama.

Watch the load during a rehearsal. Add your cameras one at a time and see where the number sits in the status bar.

Available now on every plan.

Asked often.

Will adding an IP camera disturb the camera already on air?

No. The new camera waits until you use it, and if the PC runs short, the guard only moves cameras that are off air. The camera on air is never touched.

I do not know what RTSP or ONVIF means. Do I need to?

Not usually. Find looks for cameras on your network and lists them. The password is the one for the camera itself. A pasted address is only there for a camera Find cannot see.

Can it control the camera's pan, tilt and zoom?

No. It reads the picture only. You still move a PTZ camera with its own remote or app, though Focus can frame a tighter shot inside the picture on MAX.

Does the sound come through the camera?

No, this is video only by design. Your sound stays on the mixer going into the Studio, and Camera Sync lines the picture up with it.

Why does it stop adding cameras when the PC is busy?

That was my ruling while building it. The PC must keep 20% free at all times, a camera only starts or climbs with 20% free, and it steps down when there is less.

What if the camera's address changes after a router restart?

Broadcasteer remembers the camera itself, not only its address, and finds it again on the network. A camera that drops also tries to reconnect on its own and says so on its tile.

How many IP cameras can I add, and can they be off site?

They count towards your plan's cameras, which is 1 on FREE, 3 on PRO and 5 on MAX and ALPHA. They must be on the same network as the PC, so an off-site camera will not join this way.

Try it on your Sunday.

Free tier, no credit card. A laptop and the phones in the room.

Try it free →